ECNC-SC04 single axis stepping motor controller/ tester
-
- Posts: 4649
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
ECNC-SC04 single axis stepping motor controller/ tester
This is a stepping motor controller ideal for using as a motor tester. With four controlling modes, it can control a stepper motor in forward, backward, mutiple swing or single swing. Low cost but very handy. It is great to be used as a power 'Z' table controller. By the way, you can use this board for different size steppers by using proper motor driver (not included).
- Attachments
-
- StepperController500.jpg (124.04 KiB) Viewed 8446 times
-
- ECNC-SC04.pdf
- (396.85 KiB) Downloaded 1231 times
Who is online
Users browsing this forum: No registered users and 2 guests