I have used construction lines in Solidworks to create perforated lines in acrylic that I can snap along. It worked great, but now any time I import a DXF with the dashed lines, it shows up as a solid line. I don't know what I changed, or if it was an update to LaserCAD. Also, any of my older pwj5 files still show the dashed lines. But, if I import the exact same DXF files I used to create those files, the lines are solid. I am running lasercad 7.92.12. Any settings suggestions?!
Regards,
taylor
Dashed Construction Lines in LaserCAD.
-
- Posts: 93
- Joined: Fri Sep 27, 2013 11:08 pm
- Contact:
-
- Posts: 158
- Joined: Mon Jan 06, 2014 4:28 am
- Contact:
Re: Dashed Construction Lines in LaserCAD.
Open your dxf in Corel draw and open LaserCad from there.
If it still doesn’t work save the file in Corel draw as a CD-R or dxf file then open LaserCad from Corel draw again.
If it still doesn’t work save the file in Corel draw as a CD-R or dxf file then open LaserCad from Corel draw again.
-
- Posts: 93
- Joined: Fri Sep 27, 2013 11:08 pm
- Contact:
Re: Dashed Construction Lines in LaserCAD.
I don't use corel draw. I draw and export directly from Solidworks 2017.
Who is online
Users browsing this forum: No registered users and 6 guests