Has or will anyone do a video for us newbies. Like the DSP control. I just did the k40 upgrade and do not have a clue of this equipment.
That part was not so bad being an electrician. Patients has run thin after having laser for 18 months going in circles only to find out that Moshi draw stuff is crap. Really will appreciate it.
Thank You,
Jeme
DSP & SOFTWARE VIDEO.
-
- Posts: 2
- Joined: Fri May 12, 2017 5:53 pm
- Contact:
-
- Posts: 21
- Joined: Mon Aug 29, 2016 3:43 pm
- Contact:
Re: DSP & SOFTWARE VIDEO.
Here are 3 videos that I made for our Makerspace members:
LaserCAD
https://www.youtube.com/edit?o=U&video_id=z_uIjQuLiUs
CorelLaser
https://www.youtube.com/edit?o=U&video_id=CTlrGJtYmYY
https://www.youtube.com/edit?o=U&video_id=V50jV3-gdQs
LaserCAD
https://www.youtube.com/edit?o=U&video_id=z_uIjQuLiUs
CorelLaser
https://www.youtube.com/edit?o=U&video_id=CTlrGJtYmYY
https://www.youtube.com/edit?o=U&video_id=V50jV3-gdQs
-
- Posts: 5
- Joined: Fri Jun 16, 2017 6:41 pm
- Contact:
Re: DSP & SOFTWARE VIDEO.
Try this instead:Mike Teachman wrote:Here are 3 videos that I made for our Makerspace members:
LaserCAD
https://www.youtube.com/edit?o=U&video_id=z_uIjQuLiUs
CorelLaser
https://www.youtube.com/edit?o=U&video_id=CTlrGJtYmYY
https://www.youtube.com/edit?o=U&video_id=V50jV3-gdQs
https://www.youtube.com/channel/UCR2yBe ... 2dup8pzcQA
Who is online
Users browsing this forum: No registered users and 6 guests