Reci Tube InstalL(SOLVED)

Post Reply
funhawke
Posts: 91
Joined: Thu May 21, 2015 9:44 am
Contact:

Reci Tube InstalL(SOLVED)

Post by funhawke »

Installing new Reci tube. Previous tube soldered reci tube indicates NO SOLDER. Attach to screws on each end with a spade connector OK?
Last edited by funhawke on Tue Jul 05, 2016 10:45 am, edited 3 times in total.
Tech_Marco
Posts: 4652
Joined: Mon Jun 15, 2009 3:00 pm
Contact:

Re: Reci Tube Install

Post by Tech_Marco »

It is not just the RECI tube alone, it is for all laser tube that you can NOT use soldering iron to make connection, otherwise you may break the seal and causing air leaking. RECI has a screw on each end where you connect the High voltage and ground wire to it.

Marco
funhawke
Posts: 91
Joined: Thu May 21, 2015 9:44 am
Contact:

Re: Reci Tube Install

Post by funhawke »

Great. The one I removed seems to be soldered but perhaps not. I will use a electrical spade connector and attach to screws at each end. thanks
funhawke
Posts: 91
Joined: Thu May 21, 2015 9:44 am
Contact:

Re: Reci Tube InstalL

Post by funhawke »

OK Tube installed fired up works. Is there a chart suggesting amp readings on various settings?
Post Reply

Return to “CO2 Laser Discussion”

Who is online

Users browsing this forum: No registered users and 6 guests