need help with DC-KIII CO2 laser engraver

Post Reply
wiccanpride
Posts: 2
Joined: Sun May 24, 2015 8:37 pm
Contact:
Contact wiccanpride

need help with DC-KIII CO2 laser engraver

Post by wiccanpride »

i purchased the DC-KIII CO2 laser engraver a little less then a year ago and have had no luck with it at all ..... i have sense learned that the Moshi software is crap so i would like to change out the board and controllers i see many kits on this site but was hoping some one could help me to find the kit that should work with my machine
Top
waltfl
Posts: 674
Joined: Thu Sep 08, 2011 5:29 am
Contact:
Contact waltfl

Re: need help with DC-KIII CO2 laser engraver

Post by waltfl »

hi there
I would recommend to buy the X7 kit it will fit in pretty much every machine.if you need more help send me a PM
greetings
walt



wiccanpride wrote:i purchased the DC-KIII CO2 laser engraver a little less then a year ago and have had no luck with it at all ..... i have sense learned that the Moshi software is crap so i would like to change out the board and controllers i see many kits on this site but was hoping some one could help me to find the kit that should work with my machine
Top
wiccanpride
Posts: 2
Joined: Sun May 24, 2015 8:37 pm
Contact:
Contact wiccanpride

Re: need help with DC-KIII CO2 laser engraver

Post by wiccanpride »

can i run the x7 kit on my normal 110 power or do i need to upgrade to 220
Top
waltfl
Posts: 674
Joined: Thu Sep 08, 2011 5:29 am
Contact:
Contact waltfl

Re: need help with DC-KIII CO2 laser engraver

Post by waltfl »

you have to specify what voltage you need
greetings
waltfl

wiccanpride wrote:can i run the x7 kit on my normal 110 power or do i need to upgrade to 220
Top
Post Reply

Return to “CO2 Laser Discussion”

Who is online

Users browsing this forum: No registered users and 2 guests