Greeting to everyone on the light object website Iam experiencing some difficulty with my new laser and was wondering if anyone could help me
I purchased the CO2 laser engraver from a seller on eBay and they have been loosely communicating with me but they have also been less than helpful.
My problems started when i tried to install the software and they gave me a corrupted install, but i got past that and found the right install, and installed the "Corel draw 12" i also installed the plugin for corel draw "corel laser", and i installed the driver for corel laser.
I launched corel draw and entered my main board information and i entered my device id information, but when i hit "starting" to start the engraving process I receive the error to insert my USB key, and i do have my usb key inserted.
the USB key is a Lihuiyu Studio Labs 2014.12.15 B
the model of the motherboard is 6C6879-LASER-M2:6
When I go into the device manager the USB is showing up as an unknown device and im not sure if there is something that i have to do with the software to get the USB key and the USB id to be recognized.
usb key help
-
- Posts: 14
- Joined: Sat Mar 28, 2015 5:12 am
- Contact:
-
- Posts: 252
- Joined: Mon Apr 07, 2014 2:23 am
- Contact:
Re: usb key help
I suspect that no part of this is a Lightobject product so you'll not find a lot of help here.
Try the Facebook page: https://www.facebook.com/groups/441613082637047/
Nick
Try the Facebook page: https://www.facebook.com/groups/441613082637047/
Nick
-
- Posts: 14
- Joined: Sat Mar 28, 2015 5:12 am
- Contact:
Re: usb key help
That makes sense, just wondered if anyone knew of any options.
Nevertheless, I'm just going to upgrade my DSP with the x7 pack on light object.
Nevertheless, I'm just going to upgrade my DSP with the x7 pack on light object.
Who is online
Users browsing this forum: No registered users and 11 guests