JLD612 / TET612 Dual Display PID Temperature Controller

Post Reply
admin
Site Admin
Posts: 32
Joined: Sun Nov 16, 2008 10:09 pm
Contact:

JLD612 / TET612 Dual Display PID Temperature Controller

Post by admin »

This is a manual to serve JLD-612 & TET-612. It also work for the JLD614. There are two models: high voltage(85V~285V) and low voltage (DC 12~32V). Programming for both models are the same.

It's better to use a SSR (solid state relay) along with this controller. Before using the controller for testing, make sure to check and set the thermocouple or it will show "EEE.E". Defaut setting is "K" type for the thermocouple.

Also, do not reverse the + / - of the thermocuple or it will read temperature up side down. For PT-100 thermocuple, the Red tag need to tap to the #8, while two blues need to tap to #9 and #10
Attachments
JLD612_Manual_2011.pdf
(372.91 KiB) Downloaded 5552 times
JLD614_500.jpg
TET612-2.jpg
Post Reply

Return to “Temperature Controller”

Who is online

Users browsing this forum: No registered users and 0 guests