L-On1 -----> L
LPWM1 -----> IN
Gnd ------> G
Channel A is the LPWM1 output from Controller
Channel B is the L-On1 output from Controller
Pressing "FRAME" this is what I'm getting on the Fluke123 Scope
The laser fires even tough "L" is High (4.6VDC)
![Image](https://www.qsl.net/k/kb0znp//Laser/Frame.jpg)
Here are the "FRAME PARAMETERS" in the RDC6445.
![Image](https://www.qsl.net/k/kb0znp//Laser/RDC6445_Frame%20Setting.jpg)
Here is what I'm getting when I press the "PULSE" Button.
![Image](https://www.qsl.net/k/kb0znp//Laser/Laser_Pulse.jpg)
So does this indicate that the Laser Power Supply is Ignoring the "L" input?
Is there anything else I can check?