Hey All,
I've found that my bed isn't level, what is the correct way to go about leveling it? Any documentation?
bed leveling procedure/instructions for LO PR 530
-
- Posts: 9
- Joined: Thu May 30, 2019 8:52 am
- Contact:
-
- Posts: 4649
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: bed leveling procedure/instructions for LO PR 530
Lose belt tension on the Z and make sure each rod can be moved freely. Then adjust the level on each rods necessary by turning the rod clockwise or counter-clockwise. Once level is set, tight the belt tension on the Z by adjusting the tension adjuster.
BTW, prior to do leveling on the Z table, you need to make sure that the desk that the machine is sitting on must be leveled. Otherwise, you won't be able to get good leveling by adjusting the rods
Marco
BTW, prior to do leveling on the Z table, you need to make sure that the desk that the machine is sitting on must be leveled. Otherwise, you won't be able to get good leveling by adjusting the rods
Marco
Who is online
Users browsing this forum: No registered users and 0 guests