Hi, can someone please tell me how to change settings on a job so that engraving starts from lower left instead of top left as is now.
Been reading the manual but can't find mention on how to do it
Thank you
Changing start position of job
-
- Posts: 36
- Joined: Thu Jan 18, 2018 10:57 am
- Contact:
-
- Posts: 67
- Joined: Tue Oct 30, 2018 11:18 am
- Contact:
Re: Changing start position of job
Go to
set system parameters
in the tab of "Workspace"
change the "Relative Position" to lets say bottom right
HIT APPLY
now the laser should start from the bottom right
set system parameters
in the tab of "Workspace"
change the "Relative Position" to lets say bottom right
HIT APPLY
now the laser should start from the bottom right
-
- Posts: 36
- Joined: Thu Jan 18, 2018 10:57 am
- Contact:
Re: Changing start position of job
Thank you very much.
Who is online
Users browsing this forum: No registered users and 11 guests