Will carry some 5V I/O board soon
Relay output
Lightobject new DSP laser controller card
-
- Posts: 4649
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
-
- Posts: 1
- Joined: Mon Oct 28, 2019 4:48 pm
- Contact:
Re: Lightobject new DSP laser controller card
HELLO
this is Jaime and I am new on this. I replace the boards from my machine and add a dsp t9 controller. at one moment tried to do a sample but in the controller appeared a display with this:
X axis cross border
press the escape key.
i dont know if wrong connections or some settings are out of parameters.
in other hand in tried to get the manual at support forum but i couldn't find it.
can somebody let me know how to get the manual for the dsp t 9 ?
this is Jaime and I am new on this. I replace the boards from my machine and add a dsp t9 controller. at one moment tried to do a sample but in the controller appeared a display with this:
X axis cross border
press the escape key.
i dont know if wrong connections or some settings are out of parameters.
in other hand in tried to get the manual at support forum but i couldn't find it.
can somebody let me know how to get the manual for the dsp t 9 ?
-
- Posts: 4649
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: Lightobject new DSP laser controller card
First, you need to check these:
1) Workspace: make sure the size you set up here is within the limit of your machine
2) 'UM' calibration
3) Machine zero and Page zero matched your HOME location
Marco
1) Workspace: make sure the size you set up here is within the limit of your machine
2) 'UM' calibration
3) Machine zero and Page zero matched your HOME location
Marco
Who is online
Users browsing this forum: No registered users and 6 guests