I ordered the JLD612 and the the PT-100. I can't get the controller to show anything but EEEE (or EEE.E). I hooked the red wire to terminal 10 and the two blue wires to terminals 8 and 9 (actually, I tried all permutations). I set IntY to P100 (and also tried P10.0).
The only thing that does seem to somewhat work is setting IntY to K (at that point the PV value shows something that seems correct).
Am I doing something wrong or do I just have a defective PT100?
JLD612/PT100 EEEE
-
- Posts: 4649
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: JLD612/PT100 EEEE
Red to #8 and two blue to #9 and #10
Make sure that you're configure the controller for "PT10.0"
Make sure that you're configure the controller for "PT10.0"
-
- Posts: 4
- Joined: Sat Mar 12, 2011 8:13 pm
- Contact:
Re: JLD612/PT100 EEEE
Thanks Marco.
Tried that as one of the permutations before, and just tried it again. Same results.
Tried that as one of the permutations before, and just tried it again. Same results.
-
- Posts: 4649
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: JLD612/PT100 EEEE
I think the problem is faulty probe. Do you have another probe that you can give a try?
-
- Posts: 4
- Joined: Sat Mar 12, 2011 8:13 pm
- Contact:
Re: JLD612/PT100 EEEE
Thanks Marco. I send a note to contactus to understand how I get it replaced.
-
- Posts: 4
- Joined: Sat Mar 12, 2011 8:13 pm
- Contact:
Re: JLD612/PT100 EEEE
Just received the replacement probe. Problem resolved. Thanks!
-
- Posts: 1
- Joined: Sat Feb 14, 2015 3:04 am
- Contact:
Re: JLD612/PT100 EEEE
Reddish colored in order to #8 as well as a couple of azure in order to #9 as well as #10
Make certain that you happen to be configure the controller intended for "PT10. 0".
______________________________________________________________________________________
http://www.realtests.com/
Make certain that you happen to be configure the controller intended for "PT10. 0".
______________________________________________________________________________________
http://www.realtests.com/
Who is online
Users browsing this forum: No registered users and 11 guests