LaserCad not communicating with X7 module

Post Reply
ToddWatson
Posts: 4
Joined: Tue Mar 21, 2017 12:43 pm
Contact:

LaserCad not communicating with X7 module

Post by ToddWatson »

I installed the latest LaserCad software and the X7 control module will not communicate through USB port or Ethernet.

I did install the USB driver and in the Communications Section of the software, the serial number listed is correct for the module.

It produces a "communication failure" when I try to read the settings from the X7.

LaserCad Communications Screen.JPG
LaserCad Communications Screen.JPG (15.2 KiB) Viewed 5575 times
Tech_Marco
Posts: 4652
Joined: Mon Jun 15, 2009 3:00 pm
Contact:

Re: LaserCad not communicating with X7 module

Post by Tech_Marco »

You may want to run RayCam to get it a try

Marco
srkinard
Posts: 6
Joined: Sun Apr 30, 2017 10:21 pm
Contact:

Re: LaserCad not communicating with X7 module

Post by srkinard »

Mine is doing this too, I can use RayCam but not LaserCad...same failure when using LaserCad to try and read the settings.

I only ask because LaserCad shows as being updated very recently and the RayCam software has been around 6 months since the last.
Tech_Marco
Posts: 4652
Joined: Mon Jun 15, 2009 3:00 pm
Contact:

Re: LaserCad not communicating with X7 module

Post by Tech_Marco »

Not all update is useful for us in general. They made small changes aiming on customers (manufacturers) in China with special need. If your card works fine there is no need to do any upgrade. If you want to use LaserCad I can send you a patch to unload RayCam . But you will not be able to come back to use RayCam

Marco
Post Reply

Return to “D40/K40 small chinese CO2 laser machine”

Who is online

Users browsing this forum: No registered users and 9 guests