Hi all, got a problem on my LO-X7 when engraving. I must have changed something but not sure where, it is engraving one letter at a time now any thoughts on what to change
Cheers
Pete
Engraving problem
-
- Posts: 26
- Joined: Fri Jun 13, 2014 3:54 am
- Contact:
-
- Posts: 492
- Joined: Fri Jan 20, 2012 1:39 pm
- Location: Appelscha, the Netherlands
- Contact:
Re: Engraving problem
It is a setting.. I thought it is on the page when you download a file to the laser, something about reorder or optimize, something..
Kees
Kees
-
- Posts: 4649
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: Engraving problem
Agreed, I think there is a setting on "Download" and you can check on it I forgot what is that but I will check it and post what I found
Marco
Marco
-
- Posts: 26
- Joined: Fri Jun 13, 2014 3:54 am
- Contact:
Re: Engraving problem
Great thanks.
Cheers
Pete
Cheers
Pete
-
- Posts: 492
- Joined: Fri Jan 20, 2012 1:39 pm
- Location: Appelscha, the Netherlands
- Contact:
Re: Engraving problem
At the other hand.. It can speed up engraving.. if the characters are spread over a wide object, the laserhead has to travel quite a distance without engraving.. Only when all characters are set close together it can be a bit slower in total..
Kees
Kees
-
- Posts: 26
- Joined: Fri Jun 13, 2014 3:54 am
- Contact:
Re: Engraving problem
Found as you said in download file, thanks for the help.
Cheers
Pete
Cheers
Pete
Who is online
Users browsing this forum: No registered users and 4 guests