How to reset on E5 pad to origin
Posted: Wed Nov 14, 2018 7:31 am
Hello,
I've just finished wiring up a DIY 500 x 300 kit with the E5 controller and LaserCad V7.98.15 . I'm running Windows 10 64bit. The Lasercad program is not connecting to the machine "communication unsuccesful" . I have rebooted, tried different USB ports, no luck. When I press Reset on the E5 keypad the gantry slams into the lower right corner and reset never completes because I hit "Stop" to halt the gantry slamming. I can hear the computer chime, like somethings trying to hookup when I hit reset on the E5 . I feel if I could get a successful reset the computer might finally recognize the machine.
Any ideas on how to set the origin on the machine via the keypad to stop the gantry slamming or any other solution to getting the computer to recognize the machine? Thanks, Mark
I've just finished wiring up a DIY 500 x 300 kit with the E5 controller and LaserCad V7.98.15 . I'm running Windows 10 64bit. The Lasercad program is not connecting to the machine "communication unsuccesful" . I have rebooted, tried different USB ports, no luck. When I press Reset on the E5 keypad the gantry slams into the lower right corner and reset never completes because I hit "Stop" to halt the gantry slamming. I can hear the computer chime, like somethings trying to hookup when I hit reset on the E5 . I feel if I could get a successful reset the computer might finally recognize the machine.
Any ideas on how to set the origin on the machine via the keypad to stop the gantry slamming or any other solution to getting the computer to recognize the machine? Thanks, Mark