Lightobject.com Support Forum

Posted: **Sun Jul 12, 2020 12:58 pm**

Marco,

Installed a T9 in a full spectrum laser. When I burn anything the power increases as it moves.
How or where do I correct this in the T9 controller? I am moving from left to right.

Thank you
Jim

Posted: **Thu Jul 16, 2020 12:32 pm**

Disconnect the laser power supply from the T9. Check the pwm pin DC voltage. If it is constant, the problem may be the laser power supply.

Lightobject.com Support Forum

T9 laser picks up power as it moves.

T9 laser picks up power as it moves.

Re: T9 laser picks up power as it moves.