water protect
Posted: Mon Jul 29, 2019 5:46 pm
Hi there
I am having a bit of a problem trying to wire up the water protect switch to the laser connection (laser 1)
Previously the machine was running with this disabled in the controller (air cooled laser), but now I am trying to connect the protect (pin 2) to ground (pin 5) through the water flow switch.
Every time I try to start a job I get a water protect message on the screen.
I have tried leaving it open circuit & I have tried shorting the pin out both with the same result.
Is there something else I am missing?
I am having a bit of a problem trying to wire up the water protect switch to the laser connection (laser 1)
Previously the machine was running with this disabled in the controller (air cooled laser), but now I am trying to connect the protect (pin 2) to ground (pin 5) through the water flow switch.
Every time I try to start a job I get a water protect message on the screen.
I have tried leaving it open circuit & I have tried shorting the pin out both with the same result.
Is there something else I am missing?