CorelDraw X7 to LaserCad to LO-E5 mirrors image
Posted: Mon Jun 17, 2019 2:32 pm
I'm baffled by an issue that has arisen. When I create an image in CorelDraw then use the macro to open up LaserCad, then download it to the LO-E5 controller, then run the job, the image is mirrored when I don't want it to be mirrored. If I create an image in LaserCad and send it to the controller there is no problem, the image appears as intended.
I know that I can simply mirror the image to start out with in Corel, and it will appear after lasering as desired, but I would like to fix the issue. Does anyone know what's going on here? Thanks, Mark
I know that I can simply mirror the image to start out with in Corel, and it will appear after lasering as desired, but I would like to fix the issue. Does anyone know what's going on here? Thanks, Mark