I notice there are 2 cables with 12 pin plugs that came with my kit. Am I to cut the 1 end off each cable and wire the cut end to ???? That's where I am right now, I need an instructable please. Preferably for the AWC708C Lite controller I purchased, covering the controller to laser tube ps, controller to drivers, etc., etc.
Thanks in advance!
AWC708C Lite Controller wiring???
-
- Posts: 30
- Joined: Tue Mar 29, 2016 5:00 pm
- Contact:
-
- Posts: 4649
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: AWC708C Lite Controller wiring???
No cut here!
Just connect the cables to CN1 and CN2 from the control unit to main board.
Marco
Just connect the cables to CN1 and CN2 from the control unit to main board.
Marco
-
- Posts: 30
- Joined: Tue Mar 29, 2016 5:00 pm
- Contact:
Re: AWC708C Lite Controller wiring???
I see it! CN1 is marked so I am assuming that the one next to it is for CN2. Thanks very much Marco.Tech_Marco wrote:No cut here!
Just connect the cables to CN1 and CN2 from the control unit to main board.
Marco
-
- Posts: 30
- Joined: Tue Mar 29, 2016 5:00 pm
- Contact:
Re: AWC708C Lite Controller wiring???
Now that I see where the 2 cables plug in from the controller to the mainboard is there a wiring manual for the rest? You know, what wires go where, is the e-kill N/O or N/C, limits N/O or N/C, etc,?
Who is online
Users browsing this forum: No registered users and 39 guests