Page 1 of 1
Type K Thermocouple
Posted: Sun Oct 09, 2011 10:06 pm
by tulsaturbo
I need to drill and tap a aluminum table to mount this thermocouple. Can someone tell me what is the thread size on the bulb end?
TIA...
Re: Type K Thermocouple
Posted: Tue Oct 11, 2011 9:40 pm
by tulsaturbo
Can someone please answer the question for me???
TIA
Re: Type K Thermocouple
Posted: Tue Oct 11, 2011 10:47 pm
by richiem
I can't find my thread gauge, but it looks like 1/4-20. Too coarse for anything metric, at least on the two K probes I have.
If I can get a good match tomorrow, I'l post back.
Re: Type K Thermocouple
Posted: Wed Oct 12, 2011 10:14 pm
by tulsaturbo
richiem wrote:I can't find my thread gauge, but it looks like 1/4-20. Too coarse for anything metric, at least on the two K probes I have.
If I can get a good match tomorrow, I'l post back.
It's a 1/4-20. Thanks... I wish this information was included with the part or at least in it's description at the storefront...