Lightobject.com Support Forum

Installing new Reci tube. Previous tube soldered reci tube indicates NO SOLDER. Attach to screws on each end with a spade connector OK?

It is not just the RECI tube alone, it is for all laser tube that you can NOT use soldering iron to make connection, otherwise you may break the seal and causing air leaking. RECI has a screw on each end where you connect the High voltage and ground wire to it.

Marco

Great. The one I removed seems to be soldered but perhaps not. I will use a electrical spade connector and attach to screws at each end. thanks

OK Tube installed fired up works. Is there a chart suggesting amp readings on various settings?