Page 1 of 1
AWC708C Lite Controller wiring???
Posted: Fri May 06, 2016 1:06 pm
by WVJoe
I notice there are 2 cables with 12 pin plugs that came with my kit. Am I to cut the 1 end off each cable and wire the cut end to ???? That's where I am right now, I need an instructable please. Preferably for the AWC708C Lite controller I purchased, covering the controller to laser tube ps, controller to drivers, etc., etc.
Thanks in advance!
Re: AWC708C Lite Controller wiring???
Posted: Fri May 06, 2016 1:31 pm
by Tech_Marco
No cut here!
Just connect the cables to CN1 and CN2 from the control unit to main board.
Marco
Re: AWC708C Lite Controller wiring???
Posted: Fri May 06, 2016 1:44 pm
by WVJoe
Tech_Marco wrote:No cut here!
Just connect the cables to CN1 and CN2 from the control unit to main board.
Marco
I see it! CN1 is marked so I am assuming that the one next to it is for CN2. Thanks very much Marco.
Re: AWC708C Lite Controller wiring???
Posted: Fri May 06, 2016 1:48 pm
by WVJoe
Now that I see where the 2 cables plug in from the controller to the mainboard is there a wiring manual for the rest? You know, what wires go where, is the e-kill N/O or N/C, limits N/O or N/C, etc,?