Lightobject.com Support Forum

Posted: **Sat Dec 26, 2015 2:19 pm**

What make this happend? one side is ok and other is not vertical

http://1drv.ms/1Iw2XCf

Posted: **Sat Dec 26, 2015 3:51 pm**

I had exactly the same problem.
Just align the lasertube and all the mirrors properly and your problem is gone..

Kees

Posted: **Sun Dec 27, 2015 7:59 am**

Techgraphix wrote:I had exactly the same problem.
Just align the lasertube and all the mirrors properly and your problem is gone..

Kees

Ok i have to try alignment again

Posted: **Sun Dec 27, 2015 3:16 pm**

Posted: **Mon Dec 28, 2015 6:49 am**

Ok, can you confirm that it was the alignment?

Kees

Posted: **Tue Dec 29, 2015 1:21 am**

Techgraphix wrote:Ok, can you confirm that it was the alignment?

Kees

yep

Cut problem