Lightobject.com Support Forum

Hello Everyone!

I am very excited to get started on the upgrade of my K40 laser!!!! I have successfully completed Step 1: The clean up & Step 2: Removal of the flat bed. Now that I am on step 3: Installation of the limit switch, I realize my laser already has two limit switches installed. So, my question is, Do I move on the the next step or do I switch out the ones that I have for the ones that came with the upgrade kit?

I really appreciate any help I can get as I am seriously over my head with this project

Keep the limit switch if it is already installed. I am assuming that it is a mechanical type switch but not the optical one.

Marco

Thank you Marco

Ok, I'm finally done with the wiring Does everyone's laser looks like it threw up wires when their done? I'm afraid to power it up