Page 1 of 1
need help with DC-KIII CO2 laser engraver
Posted: Sun May 24, 2015 8:47 pm
by wiccanpride
i purchased the DC-KIII CO2 laser engraver a little less then a year ago and have had no luck with it at all ..... i have sense learned that the Moshi software is crap so i would like to change out the board and controllers i see many kits on this site but was hoping some one could help me to find the kit that should work with my machine
Re: need help with DC-KIII CO2 laser engraver
Posted: Mon May 25, 2015 2:45 am
by waltfl
hi there
I would recommend to buy the X7 kit it will fit in pretty much every machine.if you need more help send me a PM
greetings
walt
wiccanpride wrote:i purchased the DC-KIII CO2 laser engraver a little less then a year ago and have had no luck with it at all ..... i have sense learned that the Moshi software is crap so i would like to change out the board and controllers i see many kits on this site but was hoping some one could help me to find the kit that should work with my machine
Re: need help with DC-KIII CO2 laser engraver
Posted: Wed May 27, 2015 8:14 am
by wiccanpride
can i run the x7 kit on my normal 110 power or do i need to upgrade to 220
Re: need help with DC-KIII CO2 laser engraver
Posted: Wed May 27, 2015 11:15 am
by waltfl
you have to specify what voltage you need
greetings
waltfl
wiccanpride wrote:can i run the x7 kit on my normal 110 power or do i need to upgrade to 220