a Forum is a great idea
Posted: Sat Jun 19, 2010 4:01 pm
Today my 612 controlling the temp of my heat treat oven died.. I got one of my 2 spare 612s and swapped it into the furnace... I would humbly suggest that the instructions should show what the letter "K" will look like on that seven segment display.. I am not certain I have it set correct for a type K thermocouple.I go thru that same difficulty every time I have setup one of these ..
.
.
I've directed several guys on couple forums to the temperature controllers from Lightobject.. I've bought 5 of the 612s so far and will order couple more I am sure.. I bought the first one BECAUSE the instructions were available online where I was able to see what I was getting before wasting time and money.Pretty good instructions overall.
.
Some years ago I bought a controller from a different ebay seller and the damned thing had instructions written by some asian retard who apparently flunked english classes, I could not begin to setup that controller by those instructions..Comical.Pathetic.Waste of money.
.
.
I've directed several guys on couple forums to the temperature controllers from Lightobject.. I've bought 5 of the 612s so far and will order couple more I am sure.. I bought the first one BECAUSE the instructions were available online where I was able to see what I was getting before wasting time and money.Pretty good instructions overall.
.
Some years ago I bought a controller from a different ebay seller and the damned thing had instructions written by some asian retard who apparently flunked english classes, I could not begin to setup that controller by those instructions..Comical.Pathetic.Waste of money.