Lightobject.com Support Forum

Posted: **Fri May 08, 2015 5:23 pm**

I just installed AWC608 DSP upgrade kit for D/K40 small CO2 laser machine. It seems to home ok, but the computer does not see it as a printer. It recognizes that something is attached to USB, but doesn't show anything. I see many people are using laserCad. Is this what drives the 608? and if so, where do I get it? or what else am I missing? Thank you in advance
Dennis

Posted: **Sat May 09, 2015 4:09 am**

LaserCAD is the necessary interface between the computer (running something like CorelDRAW – or others) and the laser machine itself.
LaserCAD is available as a free download from this site (just search)
Nick

Lightobject.com Support Forum

installed AWC608 DSP upgrade kit what runs it?

installed AWC608 DSP upgrade kit what runs it?

Re: installed AWC608 DSP upgrade kit what runs it?