Page 1 of 1
Code to write parameters.
Posted: Mon Jun 07, 2010 3:38 am
by dekaltrim
Hi.
Then i want to write parameters to the PH-board from Rlasercut it ask for password. I have tried with the six digit number included in install package but i will not work. Any suggestions?
Best regards, Klas Pettersson - Sweden.
Re: Code to write parameters.
Posted: Mon Jun 07, 2010 10:33 am
by Tech_Marco
811104 (Master key code to release demo time)
9xfc88 (Write)
Re: Code to write parameters.
Posted: Mon Jun 07, 2010 10:55 am
by dekaltrim
It gives password error. I change something on X-axis and push write. Then i type 9xfc88. And i get password error back as answer. My card is PH/Board v1.2 and i download rlasercut from your pages yesterday.
And the code button under settings is grey and not possible to use.
Re: Code to write parameters.
Posted: Mon Jun 07, 2010 12:21 pm
by maralb
Pm
Re: Code to write parameters.
Posted: Mon Jun 07, 2010 12:37 pm
by Tech_Marco
How about "634590"
Re: Code to write parameters.
Posted: Mon Jun 07, 2010 4:44 pm
by dekaltrim
It was wrong code. It should be gxfc88 instead of 9xfc88. so it solved now with a little bit help.
Thanks.
Re: Code to write parameters.
Posted: Mon Jun 07, 2010 10:20 pm
by Tech_Marco
Ding~~~ how could I miss that! Yes, it's 'g' not '9'
Thank you
