Lightobject.com Support Forum

For some reason i cant get the Z table to work on my machine.....Anybody have a decent diagram on hooking it up to the X7 DSP?

Thanks
Mike

The connection is the same as X or Y axis. You may want to use 1/8 for the micro stepping and lose the lead screw a little.

Marco

Still cant figure it out....Anybody have one working that can tell me which pin goes where?

Thanks

Does it matter which one of the pairs are + and -?

I have it as follows

Pin1- Brown to A-
Pin3- Orange to B-
Pin4- Red to A+
Pin6- Yellow to B+

I know it has to be something silly right in front of my face but i cant see it.......

Also the controller at the moment is set at

1.5 amps
8 steps

But i have tried multiple configurations.....

Thanks
Mike

Hello Mike:

Can you check the motor to sort out the pair: A+ A- and B+ B-
The cable could be wrong as we have a batch that came with different configuration

Use a Ohm meter to check the resistance. If you can see some resistance (not open circuit), then it is a pair of either A or B

The pair could be 1&4, 3&6 or 1&3, 2$4


Marco

Tech_Marco wrote:Hello Mike:

Can you check the motor to sort out the pair: A+ A- and B+ B-
The cable could be wrong as we have a batch that came with different configuration

Use a Ohm meter to check the resistance. If you can see some resistance (not open circuit), then it is a pair of either A or B

The pair could be 1&4, 3&6 or 1&3, 2$4


Marco

Got it to work Finally......The pairs are 2/4 and 3/5 So had to change the pin out to terminals 2/3/4/5

Thanks for the Help