Lightobject.com Support Forum

Posted: **Sun Aug 10, 2014 12:58 pm**

I think the picture says it all!
Top (first) one showed the problem which - unusually - then went ahead and 'corrected' itself (a bit too late to be useful).
A second print under identical conditions worked perfectly.
Any thoughts please? This happens a lot and is VERY FRUSTRATING!!!!!
Nick

Note: The picture has been rotated by the board (forum) software, the one on the left is the 'top' picture and the jump is on the x axis.

download/file.php?mode=view&id=2082

Posted: **Mon Aug 11, 2014 9:56 am**

Nick:

I sent you links for new OS patch. Try it and let me know if it fix the problem

Marco

Posted: **Mon Aug 11, 2014 11:02 am**

Thank you Marco - I'll try that over the next day or two (after I've finish installing my new air-curtain and air-jet)
Nick

update: It wouldn't update (gave the message 'update error'). Wrote to Marco, moaning. Had my tea. Had a think. Searched the forum for 'upgrade error'. and FOUND THE ANSWER!!!!
USB stick wasn't formatted to FAT32 which is an essential prerequisite!
Thanks forum!

Posted: **Mon Aug 11, 2014 8:08 pm**

Nick, I like the way you solved the problem. At least you give your best try. That will make you a good troubleshooting guy!

Marco

Lightobject.com Support Forum

Engraving (only?) jumps its x=0 point halfway through

Engraving (only?) jumps its x=0 point halfway through

Re: Engraving (only?) jumps its x=0 point halfway through

Re: Engraving (only?) jumps its x=0 point halfway through

Re: Engraving (only?) jumps its x=0 point halfway through