Page 1 of 1
Correct type Power Supply?
Posted: Tue Feb 05, 2013 4:44 pm
by wrench
Can I use this Power Supply with the DSP Conversion? The Contacts have no labels or markings e.g TH,TL...
Re: Correct type Power Supply?
Posted: Tue Feb 05, 2013 4:50 pm
by Tech_Marco
Look like OK.
The terminals should be arranged like this:
TH TL WP GND IN +5V
If you tide TL, WP to the ground and +5V to the IN, it should fire in 100%
Marco
Re: Correct type Power Supply?
Posted: Fri Oct 25, 2013 2:56 pm
by wrench
Tie like this?
Re: Correct type Power Supply?
Posted: Fri Oct 25, 2013 3:32 pm
by Tech_Marco
Yes. But I'll add a push button switch between "TL" and the "GND". That way, you can manual control it On or Off by the button switch
Marco
Re: Correct type Power Supply?
Posted: Sat Oct 26, 2013 11:27 am
by wrench
Like this? And what will this button control?
Re: Correct type Power Supply?
Posted: Sat Oct 26, 2013 11:33 am
by Tech_Marco
No, that is no difference at all.
Break the connection on #2,#3 (counting from Left to Right) then add a push button
Marco
Re: Correct type Power Supply?
Posted: Sat Oct 26, 2013 3:23 pm
by wrench
Like this?
Re: Correct type Power Supply?
Posted: Sat Oct 26, 2013 4:24 pm
by Tech_Marco
You got it
Re: Correct type Power Supply?
Posted: Sun Oct 27, 2013 10:13 am
by wrench
In my first post on this thread I posted three pictures of my Power Supply.
The second picture show a big RED cable that goes to the tube.
The third picture shows a smaller RED cable that I think went to the old analogue gauge. Where does this wire go to now?