Where to find DSP Software ?

SWMS · Post by **SWMS** » Wed May 28, 2014 12:34 am

Hi Marco, whats the latest version of the software and firmware?

Thanks.

Tech_Marco · Post by **Tech_Marco** » Wed May 28, 2014 9:42 am

LaserCad V6.88B
Hardware: 140220V7

Techsavvy34 · Post by **Techsavvy34** » Fri May 30, 2014 9:30 am

Hey Marco,
Could you send me the link for the software, firmware and manual. My order number is 201625.
Thanks.

lcornwell36 · Post by **lcornwell36** » Sat May 31, 2014 8:26 pm

Could you send me the link for the software, firmware and manual. My order number is 201617.
Thanks,
Lee

Tech_Marco · Post by **Tech_Marco** » Sat May 31, 2014 9:25 pm

Done. Check email or PM

Marco

jeffrecords · Post by **jeffrecords** » Sun Jun 01, 2014 12:34 am

Hey Marco, Can you send me a link to software/firmware thanks.

alex · Post by **alex** » Thu Jun 12, 2014 10:03 pm

Dear Marco,
Can you send me a link to software/firmware thanks.
My order# 201708.

Alex.

LaserGoodies · Post by **LaserGoodies** » Fri Jun 13, 2014 5:39 pm

Can i get the most up to date software and firmware thanks.

Order Number:
198784

robglacier · Post by **robglacier** » Tue Jun 17, 2014 9:12 pm

Hi Marco
can I please get the LaserCAD software link and any documentation for the DSP upgrade too?
order number: 113225B

Thanks.
Rob

peicharles · Post by **peicharles** » Thu Jul 03, 2014 7:49 pm

Can you send me link to the software please. Order number :201800

SScnc · Post by **SScnc** » Fri Jul 04, 2014 5:13 pm

Marco, Please send me LaserCAD software, I need to load it on a new PC.

My Order Number is: 189799

I hope it works on Windows 8.1

Thanks

Tech_Marco · Post by **Tech_Marco** » Sat Jul 05, 2014 8:18 am

Are you running PHCad or LaserCad?
Can you take a picture of the mainboard for me to look at it?

Marco
(in China)

NickWL · Post by **NickWL** » Sun Jul 06, 2014 8:32 am

Marco
I bought my DSP in early April this year, should I be upgrading my firmware or not?
Nick L

dgtaylor45 · Post by **dgtaylor45** » Sun Jul 06, 2014 8:52 am

I also need new software and firmware. Order 198443. Thanks.

SScnc · Post by **SScnc** » Sun Jul 06, 2014 9:52 am

Tech_Marco wrote:Are you running PHCad or LaserCad?
Can you take a picture of the mainboard for me to look at it?

Marco
(in China)

If that was meant for me, LaserCAD. I just got your email, thank you !!!

Let me know if you need a pic of the main board.

Lightobject.com Support Forum