California (Sacramento) CO2 laser machine support
http://www.lightobject.info/
What password are you using? The correct one is ph123TeacDance wrote:Now all connected but some problem i have
how i can go change the parameters? i put phcad password but always it say password error!
is password change?
other problem is limit switch
Thaxs that workin i try wron gxfc88twehr wrote:What password are you using? The correct one is ph123TeacDance wrote:Now all connected but some problem i have
how i can go change the parameters? i put phcad password but always it say password error!
is password change?
other problem is limit switch
Yeppii now limits working next laserTeacDance wrote:Thaxs that workin i try wron gxfc88twehr wrote:What password are you using? The correct one is ph123TeacDance wrote:Now all connected but some problem i have
how i can go change the parameters? i put phcad password but always it say password error!
is password change?
other problem is limit switch
do you have limit switch diagram now i when i push switch led go on is that correct?? when i drive home motor not stop? what my connet wrong?
TeacDance wrote:Now all working allmoust rightTeacDance wrote:Thaxs that workin i try wron gxfc88twehr wrote:What password are you using? The correct one is ph123TeacDance wrote:Now all connected but some problem i have
how i can go change the parameters? i put phcad password but always it say password error!
is password change?
other problem is limit switch
do you have limit switch diagram now i when i push switch led go on is that correct?? when i drive home motor not stop? what my connet wrong?only arrow direction is wrong but if i change direction my reset direction change same is that bossible change some another way?
Yeppii now limits working next laser
anybody know that resistor?TeacDance wrote:Couple pictures of my conversion... do i have to use that big resistor look picture 1567 right side??? now it's not use but it's working
That was part of your original power for the laser tube. Don't need it with standard laser power supplies (like the ones from LightObject and other sources). Take it out and forget it.TeacDance wrote:anybody know that resistor?TeacDance wrote:Couple pictures of my conversion... do i have to use that big resistor look picture 1567 right side??? now it's not use but it's working
Ok..twehr wrote:That was part of your original power for the laser tube. Don't need it with standard laser power supplies (like the ones from LightObject and other sources). Take it out and forget it.TeacDance wrote:anybody know that resistor?TeacDance wrote:Couple pictures of my conversion... do i have to use that big resistor look picture 1567 right side??? now it's not use but it's working
Means you are too close to the edge of your useable work area for the speed you are wanting to engrave. To engrave, it takes extra space before and after the x sweep to get up to speed. Move your origin so you have more room to left and right of engraved area.TeacDance wrote:What meaning when laser display say " Not enough extend space please esc"