Here is a cheat sheet for the output condition of the X7
Out1: '0V' when system idle. Appear'24V' when gantry is moving
Out2: '0V' when not firing. Appear '24V' when laser is firing
Out6: '0V' when system is idle. Appear '0V' when gantry is moving. Appear '24V' when gantry is moving AND 'Air assist' is Enabled in LaserCad checkbox
Marco
LO-X7 DSP controller card Output control
-
- Posts: 4649
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Who is online
Users browsing this forum: No registered users and 1 guest