Hi everybody,
With a draw in lasercad to engrave and after to cut happens a thing:
all time i have to resset table to begin the cut, in other hand the cut stay out.
why this happen ? ( detail: the steps are 100%, no lose )
Zero Point
-
- Posts: 4649
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: Zero Point
Did you mean after engraving job done, the cut didn't start from the same location?
I'm a little confuse. Can you post an image of the design and after cut?
Marco
I'm a little confuse. Can you post an image of the design and after cut?
Marco
Who is online
Users browsing this forum: No registered users and 2 guests