Array replication settings

Post Reply
Hydrops
Posts: 36
Joined: Thu Jan 18, 2018 10:57 am
Contact:

Array replication settings

Post by Hydrops »

Hi,

I'm doing a job using the array replication from lasersoft software but I notice that although it is indeed doing the array it is doing one by one, meaning it engraves one piece, then cuts it and moves to the next one.

How can I make it engrave all the parts in one turn and next cut them altogether ?

I have thousand of parts to engrave and cut and this way it'll take much longer.

Thank you
Last edited by Hydrops on Fri May 18, 2018 9:34 am, edited 1 time in total.
Hydrops
Posts: 36
Joined: Thu Jan 18, 2018 10:57 am
Contact:

Re: Array replication settings

Post by Hydrops »

So I found out a way to do it

It might help so the way I did it was to do the array copy before transferring to bitmap, is this the correct way to do it ?
Post Reply

Return to “DSP T9”

Who is online

Users browsing this forum: No registered users and 16 guests