Return home after job
-
- Posts: 44
- Joined: Thu Oct 22, 2015 9:35 pm
- Contact:
Return home after job
Is there any setting that I can change that will make the laser return to its home position after it has finished doing its job? Right now it just returns to whatever corner I started the job at, but I would prefer it move out of the way completely on its own. Thoughts?
-
- Posts: 9
- Joined: Thu Mar 31, 2016 10:04 am
- Contact:
Re: Return home after job
Please do this in the LCD control panel:
Menu->common parameters setting-> work mode->go back position ->zero coordinate.
Menu->common parameters setting-> work mode->go back position ->zero coordinate.
-
- Posts: 44
- Joined: Thu Oct 22, 2015 9:35 pm
- Contact:
Re: Return home after job
Is that for the AWC-608? I don't remember seeing a settings like that.jhuangupp wrote:Please do this in the LCD control panel:
Menu->common parameters setting-> work mode->go back position ->zero coordinate.
-
- Posts: 9
- Joined: Thu Mar 31, 2016 10:04 am
- Contact:
Re: Return home after job
Th feature is currently available to X7 DSP controller.
Who is online
Users browsing this forum: No registered users and 7 guests