Attached is a screen shot of the simulation. Two squares, 4 circles. The problem is the laser doesn't shut off between objects so my cuts look just like the simulation.
Any advice?
AWC608 controller. Universal 60watt co2 laser
Laser not switching off between cuts
-
- Posts: 15
- Joined: Sat Jan 03, 2015 4:15 pm
- Contact:
-
- Posts: 4647
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: Laser not switching off between cuts
Check the "TL" or "TH" connection between the DSP card and the power supply. You may have wrong connection
Marco
Marco
-
- Posts: 15
- Joined: Sat Jan 03, 2015 4:15 pm
- Contact:
Re: Laser not switching off between cuts
Turns out the problem was I had my settings set to glass tube. When I switched it to RF everything fired fine.
Who is online
Users browsing this forum: No registered users and 28 guests