Laser not switching off between cuts

Post Reply
Agent Sevan
Posts: 15
Joined: Sat Jan 03, 2015 4:15 pm
Contact:
Contact Agent Sevan

Laser not switching off between cuts

Post by Agent Sevan »

Attached is a screen shot of the simulation. Two squares, 4 circles. The problem is the laser doesn't shut off between objects so my cuts look just like the simulation.
Any advice?
AWC608 controller. Universal 60watt co2 laser
Image
Top
Tech_Marco
Posts: 4647
Joined: Mon Jun 15, 2009 3:00 pm
Contact:
Contact Tech_Marco

Re: Laser not switching off between cuts

Post by Tech_Marco »

Check the "TL" or "TH" connection between the DSP card and the power supply. You may have wrong connection

Marco
Top
Agent Sevan
Posts: 15
Joined: Sat Jan 03, 2015 4:15 pm
Contact:
Contact Agent Sevan

Re: Laser not switching off between cuts

Post by Agent Sevan »

Turns out the problem was I had my settings set to glass tube. When I switched it to RF everything fired fine.
Top
Post Reply

Return to “DSP X7”

Who is online

Users browsing this forum: No registered users and 33 guests