Hi Marco and others.
I have just purchased 3 of your drivers and a numbers of other bits and bobs its all turned up and in good condition I also would like to thank you for getting it to me so quick.
Anyway was hoping you could help me a little more just don't want to make any mistakes and kill the controller.
I have the following pins on the Driver you supplied me.
PLS+
PLS-
DIR+
Dir-
ENA+
ENA-
Following Pins on the MP6535
Dir
Pul
+5V
So what do you think = what lol.
MPC 6535 Dir =
MPC 6535 Pul =
MPC 6535 5v =
Anyhelp is much appreciated.
Willy AKA Sean
2M542 Micro Step Drivers + MP6535 Controller
-
- Posts: 1
- Joined: Mon Jun 28, 2010 10:53 pm
- Contact:
-
- Posts: 4647
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: 2M542 Micro Step Drivers + MP6535 Controller
I'll post more information later. Following is a manual of MC6515, Setup manual of my DSP card (written by Tim), and a basic connection diagram of the card
- Attachments
-
- DSP TYPICAL MINIMUM OPERATIONAL CONNECTIONS.pdf
- (2.7 MiB) Downloaded 222 times
-
- Light Object DSP Controller Setup Guide.pdf
- (477.93 KiB) Downloaded 219 times
-
- MPC6515 Manual.pdf
- (495.95 KiB) Downloaded 211 times
Who is online
Users browsing this forum: No registered users and 108 guests