Hi.
Then i want to write parameters to the PH-board from Rlasercut it ask for password. I have tried with the six digit number included in install package but i will not work. Any suggestions?
Best regards, Klas Pettersson - Sweden.
Code to write parameters.
-
- Posts: 8
- Joined: Mon Jun 07, 2010 3:34 am
- Contact:
-
- Posts: 4647
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: Code to write parameters.
811104 (Master key code to release demo time)
9xfc88 (Write)
9xfc88 (Write)
-
- Posts: 8
- Joined: Mon Jun 07, 2010 3:34 am
- Contact:
Re: Code to write parameters.
It gives password error. I change something on X-axis and push write. Then i type 9xfc88. And i get password error back as answer. My card is PH/Board v1.2 and i download rlasercut from your pages yesterday.
And the code button under settings is grey and not possible to use.
And the code button under settings is grey and not possible to use.
-
- Posts: 25
- Joined: Wed Dec 30, 2009 2:01 am
- Location: Italy
- Contact:
-
- Posts: 4647
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: Code to write parameters.
How about "634590"
-
- Posts: 8
- Joined: Mon Jun 07, 2010 3:34 am
- Contact:
Re: Code to write parameters.
It was wrong code. It should be gxfc88 instead of 9xfc88. so it solved now with a little bit help.
Thanks.
Thanks.
-
- Posts: 4647
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: Code to write parameters.
Ding~~~ how could I miss that! Yes, it's 'g' not '9'
Thank you
Thank you
Who is online
Users browsing this forum: Bing [Bot] and 116 guests