Where to find DSP Software ?

[Mangus]

Hi Marco,

I'd appreciate a link to the latest software. I'm currently on 6.88. Order # 199500.

-Mark

[prcdslnc13]

I would as well. Order #116217B

[clivegriffiths]

Hi, Software download link please. Order No. 203679

[Boostinben]

I am also looking for the latest DSP software, LaserCad My Order # is 116330B I have the AWC708C / LO-X7

Thanks!

Ben

[mstang64bb]

Marco~

I too, need to gat another copy of the software and driver for AWC608

MY order# 189077

Thanks, Bob

[Jason]

Need the software to please.

Order# 203885

Regards Jason

[scapaflyer]

Hi There
I have just received my new X7 dsp controller today
Order #116258B
Please could you tell me where I can get the software to use with this controller, also is there a wiring diagram available.
I have received the installation guide that you sent me the link to, however it is not for the X& controller, are there any differences, as I am putting it in to a laser other than a K40, so a diagram would be helpful
Many thanks
Scapaflyer

[Tech_Marco]

If you received the link of connection diagram, how strange you didn't get the software as we sent all together. Anyway, I "PM" you the links. The connection is for AWC608 and X7 is almost identical. Both are using same connection pin and legend mark are 99% the same. There are may be an extra pin for the X7 and you don't need to use it


Marco

[zachjowi]

Hello, Can you please send me the link for the AWC608 software and any useful information.

Order # 197939

[mikenmel08]

Can I go ahead and get any software and documentation I might need? Just placed my order....#203948 1 of: X7 DSP upgrade kit for D/K40 small CO2 laser machine

[Techsavvy34]

Hey Marco, Can you send me the lasercad software and the firmware for the awc608. My order number is 201625.
Thanks Luke

[Tech_Marco]

Please check your "PM" box

Thx
Marco

[oscarl]

Good afternoon.

After staring at all the parts I ordered for a few weeks I finally started my upgrade. I was frankly intimidated since I had not soldered anything in over 25 years but I should hopefully be done with everything by this weekend (as long as I don't blow anything up). A big thanks to all the folks that contributed to the wiring diagram on this forum. There is absolutely no way I could have done it without it.

And now the same question. How can I get the software to run my new controller? My order number was 203728.

Thank you,
Oscar

Correction: Marco. Sorry wrote the wrong order number: It was #116366B for the X7 dsp controller purchase.

I successfully installed the hardware this weekend so just waiting on the software to start having fun. The original order just had this forum for reference. Was there anything else that is needed?

[MrWoodyCrafts]

Marco,
Will you please email me the link for the software and anything else that will be help full setting up my new X7, email it to the paypal address on the invoice. Order # 204093, Do you know of anybody trying to run it with Enroute 4 ?
Any input ?

Thanks,
Tony

[ukanduit]

Hello Marco,

Please send me the link to the LO-X7 software. My order number is 208197
Send it to the email address I used to place the order.
Thank you!