Hardware Limit and Latest X7 DSP Patch issues

[enphecktor]

Recently I purchased some new limit switches and wanted to add them to my machine to protect it. In Lasercad when I read the setting from the DSP the hardware limit option comes back unchecked. I check it and save and it does not take.

So I thought I would update to the latest x7 patch that Marco posted. This didn't change anything. However now I can no longer load large files to the DSP I have tried over the network and directly from a usb stick. These are project files that I had saved and ran before the update fine.

So my question is does the DSP have enough memory to support high detail raster images on a large table? Maybe it's not a memory issue at all. It loads smaller files fine though.

Worst case I can load the previous patch and it should work again.

Any help would be appreciated.

[Tech_Marco]

How big of your file?
Can you send it to me for testing?

Marco

[enphecktor]

I have worked out the large file issues, however on both X7 DSP's I have the issue with hardware limit option not saving, Always returns unchecked when you attempt to read settings.

Any thoughts on that?

[Tech_Marco]

You need to hit "Read" first, the hit "Save"
To take the new parameters in effect, press "Reset"

Marco

[enphecktor]

Marco,

I tried as you recommended. On both machines. Hardware limits come back unchecked. I tested machine to see if maybe the settings took in the DSP and the limits failed to stop the axis.


From LaserCad, I read the settings, Check the hardware limit box, save settings enter password. Hit ok. Then hit reset on the DSP.

Is this not correct or is there something else I can try?

Thank you.

[Tech_Marco]

Can you post your screen? It is so odd as I never seems such problem before.
May be you want to reinstall the LaserCad

Marco