Password required for saving settings to T9 controller
Posted: Mon Nov 13, 2023 3:20 am
Hi,
I recently finished my K40 rework to T9+ controller. I also installed LaserSoft V7.22.23, which works very well so far. But still there is an issue with the settings transfer to the controller. When I set up the system parameters like the pulse units for x and y axis, I cant save them on the controller because LaserSoft asks for a password. What is this password and where can I get it (or better: get rid of it ). See screenshot:
https://ibb.co/zVfbYLj
I recently finished my K40 rework to T9+ controller. I also installed LaserSoft V7.22.23, which works very well so far. But still there is an issue with the settings transfer to the controller. When I set up the system parameters like the pulse units for x and y axis, I cant save them on the controller because LaserSoft asks for a password. What is this password and where can I get it (or better: get rid of it ). See screenshot:
https://ibb.co/zVfbYLj