LaserSoft questions

[marko53]

Hello,
I upgraded from the LO-E5 w/ Lasercad to the T9+ controller w/ Lasersoft. So far so good. Is there an option in Lasersoft for changing the units
from Metric to Imperial?
Also, when I have an image in Coreldraw positioned to one side of center, and then use the Macro to send it to Lasersoft, Lasersoft places the image
in the center of the Lasersoft workspace rather than to one side or the other which is what I would like. Can this be changed?
Thanks, Mark

[Tech_Marco]

1) Only metrix is supported
2) The system always exported to the center because the system can't tell where the side is. Remember that there is no 'boundary' in CorelDraw.

Marco