lasersoft feature request
Posted: Thu Jan 30, 2020 7:30 am
It will be nice if lasersoft has a version that can control the outputpins. Instead of airblow on/off, make them pin1 on/off,pin2 on/off...
Will be even better if we can customize input pins. Instead of door/water protection, make them pin1 high=stop the machine/=turn on output2... So that T9 is not limited to laser machine only.
Otherwise T9 is not much different than other controllers. It can be a top choice for DIYers who don't like programming arduino.
Will be even better if we can customize input pins. Instead of door/water protection, make them pin1 high=stop the machine/=turn on output2... So that T9 is not limited to laser machine only.
Otherwise T9 is not much different than other controllers. It can be a top choice for DIYers who don't like programming arduino.