Cohesion3D and the K40
Posted: Mon Nov 04, 2019 2:47 am
Hi all, I have a question about working with the C3D controller.
I have build it in and everything works fine except,, When the laser is working on a laser object its going fine. But when the laserhead is moving to the next object is it moving in Super Turbo mode. It sometimes even skip a ribbon on the belt..
I want to know how to adjust the speed between the laser commands.
Regards
Maarten
I have build it in and everything works fine except,, When the laser is working on a laser object its going fine. But when the laserhead is moving to the next object is it moving in Super Turbo mode. It sometimes even skip a ribbon on the belt..
I want to know how to adjust the speed between the laser commands.
Regards
Maarten