Z Table Driver
Posted: Tue Feb 28, 2017 11:41 am
Hi,
After a loooooooong shipping time from US to Sweden i finally assembled my Z table without any problem.
I also bought the suggested driver DM422 from Lightobject.
Want to use it in a standard D40/K40 with my smoothie board clone. No display on the machine.
How do I wire it to move the z table up and down?
How to wire it between motor and driver is no problem, but on the other side?
After a loooooooong shipping time from US to Sweden i finally assembled my Z table without any problem.
I also bought the suggested driver DM422 from Lightobject.
Want to use it in a standard D40/K40 with my smoothie board clone. No display on the machine.
How do I wire it to move the z table up and down?
How to wire it between motor and driver is no problem, but on the other side?