I have a high quality power Z table for sale. It is made of stainless steel with "86" high torque motor. It is deisgned for a 600X400 laser machine. I'll measure the over-all dimention and post more here soon
Price: $750 + S/H + Tax (CA only)
Get it before too late!!
Let me know if anyone interested.
Marco
Stainless steel Power Z table for 600x400
-
- Posts: 4647
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
-
- Posts: 2
- Joined: Thu May 08, 2014 11:38 am
- Contact:
Re: Stainless steel Power Z table for 600x400
Hi Marco,
Are these 2 or three phase motors on these tables. I am looking at buying the 900 x 1200 table and need to know that driver to buy. Also what is the total z travel - let me know - thanks
Are these 2 or three phase motors on these tables. I am looking at buying the 900 x 1200 table and need to know that driver to buy. Also what is the total z travel - let me know - thanks
-
- Posts: 4647
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Re: Stainless steel Power Z table for 600x400
It is driven by a big 2 phase motor (86 series). I do have 1200x900 power Z table. The range is about 250mm and I'll make a measurement tomorrow
Marco
Marco
-
- Posts: 288
- Joined: Sun May 23, 2010 6:40 pm
- Location: Broken Hill, NSW, Australia
- Contact:
Re: Stainless steel Power Z table for 600x400
Hello Marco, It's been a while since I've been on here. Been very busy with work.
Have you thought about a scissor lift for the table? You would only need 1 motor and screw and you could use 2 full ball bearing drawer slides on the back of the table to keep everything square and stable.
Just a thought. That is what I am going to use for my next table build when I get the time.
Rich.
Have you thought about a scissor lift for the table? You would only need 1 motor and screw and you could use 2 full ball bearing drawer slides on the back of the table to keep everything square and stable.
Just a thought. That is what I am going to use for my next table build when I get the time.
Rich.
-
- Posts: 4647
- Joined: Mon Jun 15, 2009 3:00 pm
- Contact:
Who is online
Users browsing this forum: No registered users and 132 guests