I purchased the "High Speed 5 Axis Break-Out Board for CNC Stepping motor. Support Mach3 and Kcam" (part number ECNC-5xBO-V8) and I need either a manual or a schematic or wiring diagram for it. I've searched everywhere and I haven't been able to find one.
Could anyone please help?
Thank you!
Need Manual or Wiring Diagram for ECNC-5XBO-V8
-
- Posts: 2
- Joined: Fri May 09, 2014 11:00 am
- Contact:
-
- Posts: 2
- Joined: Fri May 09, 2014 11:00 am
- Contact:
Re: Need Manual or Wiring Diagram for ECNC-5XBO-V8
Has anyone found the manual? I've searched the internet quite a bit and haven't found another place to get this information.
Thank you!
Thank you!
Who is online
Users browsing this forum: No registered users and 2 guests